Question:
    Dear sirs, I nedd some information in regards to the low throttle needle setting. I have run this motor in and I tried to get it to tick over. However I didnt pay attention to where the setting was in the first place. Would it be possable to tell me how many turns are for the factory setting so I can start again.. Thank you for your help.. George
Answer:
    Dear George, Thanks for your email. When assembling the engine in the factory, the flow rate is not set up by specific turns of the screw but measured with an instrument. We are sorry that we can not provide you with a definite data regarding how many turns the screw should be. Please refer to the manual for F-91S in the below ftp file or contact ACEHOBBY DIST. AUSTRALIA P.L. for technical support. ftp://ftp.thundertiger.com ID: mac313 Password: ttmac345 ACEHOBBY DIST. AUSTRALIA P.L. Tel: 61-2-9602-6153 Fax: 61-2-9602-6298 E-mail: steven@acehobbyaustralia.com.au Web: www.acehobbyaustralia.com Best regards, Customer Service Thunder Tiger Corp. [ Simon ]